Thread: kenwood dnx9260bt mass storage deleted

Originally Posted by mylona79

does anybody know for sure how to enter in pre boot mode?

Everything you do, you do so at your own responsibility.
I am not responsible for yours errors, mistakes and damage created and ......

Tested by me and it works on Kenwood DNX9260BT with navigation module W02-5378-45.
To enter pre-boot mode, follow photos.

Spoiler: images

[Only registered and activated users can see links. ] [Only registered and activated users can see links. ]

[Only registered and activated users can see links. ]

Attention!!!!

These wires must be very thin and very flexible.

Even less than what I used here:

Spoiler: images

[Only registered and activated users can see links. ] [Only registered and activated users can see links. ]

Please be very carefull with solder these wires.
Soldering contacts are very small and fragile.
Do not use a high temperature solders.
You will need a skill for electronics.
If you do not have this, you will destroy the module, irremediably.

Like in this picture:

Spoiler: image

[Only registered and activated users can see links. ]

If you happened so, you still have a chance, one last chance.
Go outside only one wire, on that you put it to ground in outside, (chassis housing or - 12V), to enter pre-boot mode.
Like in this picture.:

Spoiler: pic

[Only registered and activated users can see links. ]

......... The discussion will continue in post #73 and #75.


Everything you do, you do so at your own responsibility.
I am not responsible for yours errors, mistakes and damage created and ......