Thread: Garmin Nuvi 1200 that gets stuck on Garmin logo

Thanks Butters for answering. Below I attach a video of the procedure and the error it gives.

Video showing the procedure and error

Spoiler: YT video

[Only registered and activated users can see links. ]

Spoiler: pic

[Only registered and activated users can see links. ]

Does not show drive in Disk Manager

Spoiler: pic 1

[Only registered and activated users can see links. ]

Does not detect drive in RMPrepUSB

Spoiler: pic 2

[Only registered and activated users can see links. ]

Thanks

P.S:

Originally Posted by julianof

2- I converted GCD to RGN with RGN Tool, just boot.bin, with the name 110601000630.rgn and uploaded it to Updater. I did the preboot and it ends successfully. Windows recognizes it but does not assign a letter to the drive. It is detected by Updater, but not RMPrepUSB. With Cure (only boot.bin) it gives the same error as in 1.
Once annealed and trying to update the complete firmware with Updater it gives the same error as in 1

3- I wanted to convert GCD to RGN with RGN Tool, only fw_all.bin and I get the error "Section 1 must be enabled. Normally it should contain section 0800 boot.bin" and it does not allow the RGN to be created

I did the test guided by the following posts

Comment #18 and #21
[Only registered and activated users can see links. ]

Also comment #22
[Only registered and activated users can see links. ]