Thread: Truck support in NG versions

O4i - as always a valuable note - although in my opinion - unfinished.
Can users not understand what is going on ...
It is like this:
Vehicle dimensions are set in the options - car (Truck, Bus etc) profiles
Based on this information - the program tests whether the set parameters exceed (or not) parameters specified for the road and "stuck" in map files (ftr, fda, ​​spc or txt) or !!! in txt (spc) files.

If this is the case - then (with the proper SPEEDCAM-CAT configuration we see it on the map, and before we can see it in the "constraint specification" and in the route description - just as we see the limitations and warnings of other categories.

In NextGen - the file corresponds to the file - vehicle_selection.zip, while the limit (for this category of vehicle) corresponds to the file - truck.zip.
Proper display of speedcam - this is speedcam.zip file, - but if there is no ftr, fda, ​​spc, or speedcam txt files - then the whole thing does not work properly.
Even when the program is "full crack" and you do not need a license - here's a minor digression - in my Basarsoft version - actually a license for Truck is required.

And so:
With a properly configured vehicle profile:

we choose the route

Spoiler: pic1

If the vehicle parameters exceed the route parameters - appear - restrictions

Spoiler: pic2

which we can see on the map

Spoiler: pic3

or in route info

Spoiler: pic4

regards wojpen