Updating Igo Primo 9.2.0.198379 for Blaupunkt NY 830

**theonet** · 27th June 2015, 10:03 AM

Hi all ! I'm trying to update the version mentioned above. Tried to replace a new map files, but without any success - the application is not loaded. I copied the original card content to another new SDHC card, but, as I said, with no positive outcome. May be, I need to update some other files, and the application itself ?

Thank you a lot for instructions !

maury22 · 28th June 2015, 02:24 PM

...........but you have Primo cracked version or not cracked version ?

Don't work maps that are in this Forum (and also in others Forum) if you have the original software version (with original license). You can only buy them through Naviextras.....

**theonet** · 28th June 2015, 02:34 PM

Yes, I have an original one. So, what is the solution - may I ask here for the new Blaupunkt NY 830 compatible IGO version with updated maps ?

Thank you very much

maury22 · 28th June 2015, 06:00 PM

I think a 2.0 or 2.4 Primo version.....
Just then rename Primo folder and executable as the originals.

I don't think there are still alive 1.2 (old) Primo versions as your original.
(note : I don't have a Blaupunkt.....)

**janch** · 28th June 2015, 08:41 PM

Rename folder Primo to RTNavi and Primo.exe to mobilenavigator.exe. Proper sys for Blaupunkt NY 830 in attachment..[Only registered and activated users can see links. ]

ps. version 9.6.13.405512 works OK. Tested on following models with the same config. and with the sys in the attachment:

New York 800/830/835 (folder: RTNavi, executable: Mobilenavigator.exe)
Philadelphia 835 (folder: RTNavi, executable: Mobilenavigator.exe)
Chickago 600 (folder: RTNavi, executable: Mobilenavigator.exe)
San Diego 530 (folder: MobileNavigator, executable: Mobilenavigator.exe)

notes:
- on a newer models New York 845 and Philadelphia 845 this version doesn't work properly (no sound at all). You need different iGO version.
- for San Diego 530 you need to change values in [gps] section in sys.txt file otherwise Primo won't recognise gps hardware. Using "Auto" values also won't help, that's why you need to specify corresponding port/baud. These are the correct values:

[gps]
port=1
baud=57600

**theonet** · 29th June 2015, 05:33 AM

Thank You. May You provide me, as well, with the 9.6.13.405512 version ?

**janch** · 29th June 2015, 07:04 AM

[Only registered and activated users can see links. ]

**theonet** · 29th June 2015, 07:20 AM

Thank You a lot ! Will it fit the maps version by this link :

[Only registered and activated users can see links. ]

Do I need to change the maps files names, as well ?

**titisoim** · 29th June 2015, 08:50 AM

it is not necessary..

**theonet** · 3rd July 2015, 05:25 PM

Hello everybody , unfortunately, I can't succeed to install properly the soft. I'll (it's not loaded by Blaupunkt). I'll be grateful for any of you step by step instructions.