Hi Butters,
Thank you for comprehensive answer.
So, I've converted [Only registered and activated users can see links. ] into RGN using RGN Tool (by default - without any custom fields and without "Preserve current..." checkbox):
Spoiler: pic 1
and named accordingly - 328801000160.RGN.
Placed near Updater and flashed it, there were no errors and success message.
How it looked on initial stuck and during Updater flashing:
Spoiler: pic 2
After I've touched the Light button - "gear update" immediately has shown and progress was increasing. However it has stopped at the middle after few minutes and was not changing during ~5 hours:
Spoiler: pic 3
So, I've decided to switch it off... After enable there were no "gear update" anymore, but increasing progress bar only (stuck at the middle as well):
Spoiler: pic 4
Windows - does not see it as storage device, only Garmin USB GPS (same as before).
WebUpdater fails as well:
Spoiler: pic 5
however now it correctly shows firmware version (16.60, previously it was showing v03.00) and device ID (3312..., previously it was 0):
Spoiler: pic 6
Garmin Express - automatically detected device (previously it was not visible to it at all) but crashed...
So as summary - something has changed, watch is almost bricked but still alive. Not sure that I should wait more than 5 hours initially when it was flashing internally.
Regarding hex editing of custom cure - [Only registered and activated users can see links. ]
It is strange but I cannot find any enumerated file extensions at RGN (.img .GCD .gpx .gpi .zip .vpm). I've attached it.
Hope you will have some ideas what is happening.
Bookmarks