Thread: GarminCure3 tool - the new way to create cure firmwares for Garmin devices

Originally Posted by kunix

Well, this is strange... it works flawlessly on my nuvi 1490.
When flashing 097201000999.rgn, try not disconnecting USB cable at all.

It even works when I insert an SD card with the following contents: (ldr.bin is the boot.bin from 097201000999.rgn)
[Only registered and activated users can see links. ]
After booting almost completely the device reboots and waits for a few tens of seconds for USB to be connected.
If I connect USB it enters the flash drive mode, otherwise it boots normally again.

tried this, it starts bootoing and the it restarts when loading maps, and continue restarting in a continuos loop.

i think i´ll give up with this one, i don´t need to connect it to my PC very often, and i can manage updates flashing the FWs and i can upload maps usind th SD card.

Thanks again guys for all yout help and for sharing your knowledge.