City Navigator Europe NT 2013.40

**prenard** · 16th March 2013, 10:53 AM

Hello,

I have installed Full Europe coverage.

In Mapsource, when I try to send maps to device (create gmapsupp.img), it fails and I get a error message "MDR_TRIM_ADDR.CXX-4014-6.16.3.0" !!!

Any help ???

Thanks

**catymag** · 16th March 2013, 02:43 PM

Originally Posted by prenard

I get a error message "MDR_TRIM_ADDR.CXX-4014-6.16.3.0" !!!

Any help ???

Thanks

You probably have a problematic tile in your map (may be corrupt), I think this one may cause the problem with writing the index.
Address search index for this region may causes Mapsource not to start and send.

**Roger** · 16th March 2013, 11:24 AM

@[Only registered and activated users can see links. ]

Meanwhile, check if the folder structure GMAP is equal with the same files

2cp8954

Bye,bye

**prenard** · 16th March 2013, 12:38 PM

Yes, it is the same structure:

[Only registered and activated users can see links. ]

**Roger** · 16th March 2013, 01:05 PM

Re-install the MapSource and re-patched this program (I use the portable version)

And try to shortcut and install the little map with MapInstall,please

Bye,bye

**prenard** · 16th March 2013, 01:44 PM

I have already done this... Same result !

**Roger** · 16th March 2013, 02:00 PM

Sorry...with MapInstall? Same error/risult?

MMhhh....re-download from post #4....and patched MS,MI and unlocked the folder GMAP with UnLock MapSource.exe

**Neil** · 19th March 2013, 11:58 AM

@tigertrader
From the Garmin wiki:

Follow these steps to simulate driving a route from A to B (you can skip steps 2 and 3 if you want to simulate a route from your current position):

1. Put the Oregon in demo mode (Setup>System>GPS>Demo Mode)
2. Select WhereTo?, pick your starting location like a waypoint, POI, etc., and press "Go". Call this point A.
3. Select "Move to Location" when asked if you want to simulate driving this route.
4. Select WhereTo? again, pick your destination location and press "Go". Call this point B.
5. Select "Yes" when asked if you want to simulate driving this route and the Oregon will simulate following the route from A to B.

Note: Depending on your location and the maps you have loaded you may get an error after step 2) indicating a "Route Calculation Error". If so, you can put the unit in Off road routing mode (Setup>Routing>Guidance Method>Off Road) prior to step 2) and back to On road routing mode after step 2) (Setup>Routing>Guidance Method>On Road For Time) to avoid the issue.

If you still can't get it to work, please PM me and i'll move these Oregon specific posts to a new thread. This is quite OT in here.

**jujo_si** · 19th March 2013, 06:27 PM

Hello,

I am using 765T and recently updated my maps to 2013.40 (I had 2013.10 before). I notice that the 3D buildings are overlapping the roads and the result is a jagged ugly map. Have you encountered such problem yourself maybe on other device models?

Check out the screenshots

[Only registered and activated users can see links. ]

[Only registered and activated users can see links. ]

Regards,