Thread: Navitel E707 Magnetic - alternate software (firmware) to run iGO Primo

Hello Everyone.
Navitel E707 Magnetic purchased in 2024.
I have already tried dozens of firmware versions. Everything was uploaded according to the instructions (SD card, 2GB, FAT, connected mains charger). Each of the available firmwares uploaded correctly, but after restarting there are the following problems:
1. Restart at the boot stage (truck symbol/navitel logo -> after a while dots on the wallpaper and restart and so on)
2. On some firmwares, reaching the calibration screen, which cannot be performed (clicking on the cross does not cause it to move around the screen)
3. On one of the firmwares (I admit that at the moment I do not remember exactly which one it was) everything starts correctly, but there is a problem with calibration, i.e. clicking on the cross changes its position, but you can click on it indefinitely (as if you cannot complete the calibration procedure). When you exit the calibration process, you can't select a street in navigation (the latest version of Igo Truck or the latest version of Automapa). It's like you can't click on the line where the street selection is (you can either click the line above or below). I assume that this is due to problems with screen calibration, which can't be performed (unless I'm mistaken). Thanks in advance for your help.

The same thing happened with the dots on the screen when I tried to flash a device with a capacitive touch screen with firmware for a resistive one. Try the one from post #11.