Thread: Toyota iGO Nextgen 9.19.1.665137 Aug 4 2016 WinCE

Heh. You ask too much
Many tried but didn't succeed ...

So far, this or 653580 have shown the most promise.
However, the different structure of the NG software, in fact its dependence on licenses, dictates the unlocking possibilities.

The link renewed in OP at user request

The first system I managed to get to work on my WinCE 6 device without any memory issue or any other bullcrap, now the question is how to get maps on it? Any suggestions? I tried to add different files but none seem to work, the basemap on it shows only country lines but when I zoom inside my country its blank and GPS says no roads next to my point. Thank you for support

Edit- Any primo suggestions are also welcome, so far tried the Honda and Kia, none worked both gave me memory error

🧭 PNI L810 – Full Specifications
📱 Display
Screen size: 7.0″ TFT touchscreen
Resolution: 800 × 480 pixels
Aspect ratio: 16:9
⚙️ Hardware & performance
Processor: MSB2531 ARM Cortex-A7
CPU speed: 800 MHz
RAM: 256 MB DDR3
Internal storage: 8 GB NAND Flash
🗺️ Navigation system
GPS channels: 64
GPS antenna: Built-in

Using with SD card - path launch to gps by exe

You should read, read, read some more – and first learn/understand, because iGO is quite unique 😉

The basemap.fbl file is just an overview map with a maximum of the highway network. For more detailed and accurate information, you need the your-Country.fbl file... and of course, the corresponding licenses for the map files.

There's a lot to do before then – get to it 👍👍😉