Updating Igo Primo 9.2.0.198379 for Blaupunkt NY 830

[theonet]

Hi all ! I'm trying to update the version mentioned above. Tried to replace a new map files, but without any success - the application is not loaded. I copied the original card content to another new SDHC card, but, as I said, with no positive outcome. May be, I need to update some other files, and the application itself ?

Thank you a lot for instructions !

[maury22]

...........but you have Primo cracked version or not cracked version ?

Don't work maps that are in this Forum (and also in others Forum) if you have the original software version (with original license). You can only buy them through Naviextras.....

[theonet]

Yes, I have an original one. So, what is the solution - may I ask here for the new Blaupunkt NY 830 compatible IGO version with updated maps ?

Thank you very much

[maury22]

I think a 2.0 or 2.4 Primo version.....
Just then rename Primo folder and executable as the originals.

I don't think there are still alive 1.2 (old) Primo versions as your original.
(note : I don't have a Blaupunkt.....)

[janch]

Rename folder Primo to RTNavi and Primo.exe to mobilenavigator.exe. Proper sys for Blaupunkt NY 830 in attachment..[Only registered and activated users can see links. ]

ps. version 9.6.13.405512 works OK. Tested on following models with the same config. and with the sys in the attachment:

New York 800/830/835 (folder: RTNavi, executable: Mobilenavigator.exe)
Philadelphia 835 (folder: RTNavi, executable: Mobilenavigator.exe)
Chickago 600 (folder: RTNavi, executable: Mobilenavigator.exe)
San Diego 530 (folder: MobileNavigator, executable: Mobilenavigator.exe)

notes:
- on a newer models New York 845 and Philadelphia 845 this version doesn't work properly (no sound at all). You need different iGO version.
- for San Diego 530 you need to change values in [gps] section in sys.txt file otherwise Primo won't recognise gps hardware. Using "Auto" values also won't help, that's why you need to specify corresponding port/baud. These are the correct values:

[gps]
port=1
baud=57600

[theonet]

Thank You. May You provide me, as well, with the 9.6.13.405512 version ?

[klimic]

Rename folder Primo to RTNavi and Primo.exe to mobilenavigator.exe. Proper sys for Blaupunkt NY 830 in attachment
...
ps. version 9.6.13.405512 works OK. Tested on following models with the same config. and with the sys in the attachment:
,,,
San Diego 530 (folder: MobileNavigator, executable: Mobilenavigator.exe)

Hi, for SanDiego modify in [gps] port=1 and add in [sound] csv_voice_enabled=1 - and it is working...

[altazor]

I have a San Diego 830 and it does not detect me the satellites putting in the sys port=1 and baud=57600.

Could someone share a copy of your Primo for San Diego 830?

Thanks.

[Jeanet]

Give this a try:
Put in sys

[gps]
port="auto"
baud="auto"

Delete save folder and startup again.

[arslankayna]

I have a San Diego 830 and it does not detect me the satellites putting in the sys port=1 and baud=57600.

Could someone share a copy of your Primo for San Diego 830?

try this:
[gps]
port=4
baud=57600
set_messages=0
sent_init_type=0
background_navigation=1