I've never made work tmc with igo8 on s575.
You should beter install primo 2.4 with a skin or an UX which allow tmc to run in station list mode.
Envoyé de mon GT-S7390G en utilisant Tapatalk
I cannot get the TMC to work on my Mio Spirit 575 with IGO8.
Is it possible to get TMC??
I've never made work tmc with igo8 on s575.
You should beter install primo 2.4 with a skin or an UX which allow tmc to run in station list mode.
Envoyé de mon GT-S7390G en utilisant Tapatalk
You have to split problem in 2 :
- hardware
Do you proper unlock ?
Does TMC port run ( see RDS info ) ?
- software ( primo )
sys.txt
license
settings primo
Last edited by costas3850; 2nd October 2015 at 10:33 AM.
I am not sure, how do I check?
I used the VisualGPS unlock method.
Unrar and copy on you card the archive below :
Spoiler: link
Plug the original cable from the battery supply ( which containing TMC antenna ) and run TMC Test Receptor.exe
If you manually entered an FM frequency you shoud receive station name (by RDS), as you see above :
If NOT, first run TMC.exe and try again.
When you'll receive RDS info first steep will be completed.
Ok, thanks.
Were exactly do i copy the unzipped files?
Do I also need to add something in the sys.txt?
Anywhere on your card.
Add in sys.txt :
Spoiler: sys
Last edited by costas3850; 2nd October 2015 at 10:36 AM.
OK, I can tune with FMx control, and it finds the station and it says TMC available and rds quality is high, but no rds info appears...
When I click tmc.exe, the device restarts....
OK, I can tune with FMx control, and it finds the station and it says TMC available and rds quality is high, but no rds info appears...
You resolved hardware part.
RDS info is FM radios's name, like EUROPA FM on my pic.
When I click tmc.exe, the device restarts....
It's OK, TMC.exe is a script wich modify some registry and make a soft reset.
You have to run it only after a hard reset ( RESET position of device's switch ).
In fact, the contents of the script TMC.script must be copied in startup script of Lanik.
Or you can revert the device to the original state and use an TMC-ready unlock, like [Only registered and activated users can see links. ].
Now, if TMC Test Receptor.exe finds the station and it says TMC available and rds quality is high, you can test with primo.
First of all use [Only registered and activated users can see links. ] or Gurjon skin.
Last edited by costas3850; 2nd October 2015 at 03:30 PM.
Bookmarks