Thread: Igo 2.4 not working. Crashes during start.

Originally Posted by zzyzxroad

...I can make my branding compatible with it. people have tried my branding but it seems to be only working on older primo versions.

Becouse of this I was thinking that that could be a problem.

I can read: Wince, generic...nothing precise.

You didn't read enough posts on this forum:
- What subversion of 2.4? Some of them are very problematic.
- Ok, generic china devices. Every, even generic device, has own ID, in system properties.
- car inbuilt or standalone units?
- what versions of WinCE are on them?
- what resolutions of screens?
- is there some special structure of folders/files on those units?
- if previous versions works, on not so old devices, than you are doing something wrong. Yes, maybe wrong sys.txt, maybe bad data.zip, maybe you didn't deleted save/userdata folders, maybe ....

Btw, on my extremely old gps device(64MB ram, 372MHz), works 2.4 version(405512). A little bit slow but works. But, when I put 2.4 on SD card, and boot device in clean mode, 2.4 work quite satisfactory.