Quote Originally Posted by Solentmancub View Post
.........
I managed to get into the Garmin & retrieve the following:
ID2077 NÜVI 25x9 Version 8.80. ......
If you mean by "the Garmin" that you either (i) got it into Preboot Mode (aka Garmin Mode) and obtained it's HWID as 2077 via [Only registered and activated users can see links. ] or (ii) from a backup of its file system, then you are safe to use the "C4" version as per above post#2.

I believe these are the next steps:
Open the .gcd in GarminCure3.
Create the Cure version and flash it with Updater.exe in preboot (same timing technique you’ve been practising).
Once the unit stays connected and appears as a drive, check/delete any obvious bad files (especially anything in the root or .System folder that looks recent or corrupted). Not needed, connect and re-do the format instead - see below
Then create and flash the original (non-Cure) version of the same firmware.
..........
Because you've likely formatted it with a Mac OS the format won't be properly acceptable to the proprietary Garmin OS. Even Windows built-in tool sometimes isn't perfect. Therefore, you need to use [Only registered and activated users can see links. ] to format it correctly in FAT32 so please read the guide in kunix's [Only registered and activated users can see links. ] carefully. The are no corrupt files on it because the previous format attempt, albeit perhaps incompatible with the device, has completely removed all folders and files. Note the final point in #2 of "The typical curing algorithm (in general) looks like this" carefully and read the entire initial post. If you have a 'known-good' backup you may restore files from it or use GarminExpress to recover them but it won't give you a [Only registered and activated users can see links. ].