Thanks for the reply catymag....thats was where i started off..and have read it many times!! lol
would my phone device showing up as an F drive instead of an E make a difference....?? I dont think so but im grasping at straws now lol
Thanks for the reply catymag....thats was where i started off..and have read it many times!! lol
would my phone device showing up as an F drive instead of an E make a difference....?? I dont think so but im grasping at straws now lol
I think you are speaking about letter drive your pc shows and it can be E or F or G,that's depends on devices you have attached to your pc.
My post spoke about the letter E that symbian os assigns to your mc card in your phone os
I explain drive letters in S60 :
C:\. This drive is also called phone memory. Basically it is a flash memory where we can install applications and store our data. Unlike memory card, it is always inside our phone. So, even if we remove the memory card, our data are still there. However, note that the size of phone memory is limited.
D:\. It is the drive used to store temporary files. The contents will be deleted when the device reboots. In many cases, we don’t use this drive.
E:\. It is the drive of your memory card. Normally, this is the place where we install applications and install our data.
Z:\. This is where the ROM image is stored. It contains all the operating system’s applications and data files. Since it is read-only memory, you cannot write anything. The only way to modify the contents of Z:\ drive is by flashing the phone, for example via Nokia Software Updater
You have to navigate to get to the good.
Galaxy S5 Kitkat 4.4.2 / Nuvi1200->1250 / Nuvi3790T->34xx / Nuvi 2200 / Nuvi 66 / Oregon 600
thanks once again for the info catymag...on my pc my n95 8gb mass memory is F:
I can now confirm that Garminmobile XT managed to show me how to get home from the school run! lol
Thanks once agaon for the invaluable adice here :D![]()
After I installed Garmin Mobile XT all issued V5... on a SE P990i (UIQ) and a N95 (S60v3) I could not succeed to change the name of a location created and stored previously in "My Location". When I do this, the application shuts down instantly and you have to restart it again. This was not the case for any of the previous V4... released by Garmin. Give it a try and tell me about your findings. Thanks.![]()
To be more specific, the restart happens when I try to go on the map to the newly created point (I changed only the name of an old point).
Bookmarks