Thread: Need Help with Bricked nuvi 1490

Thank you. This is not the problem.
I created the gcd file no problem. (on the right)
I then dragged it into the updater and set it to USB.
I then pluged the cable into the GPS while holding the top left.
The process started and I got the updating to show on the gps.
Now this is the problem: a few seconds after the erasing phase starts (top left), the application stops with the error from bottom left.
The gps goes back to the boot loop: goes to Garmin logo, stays there and then restarts.
At no point the computer sees the gps.
I installed the drivers correctly, I have other units that connect just fine on the same computer with the same cable but this gps never goes into Mass Storage as the updater crashes with the error from above bottom left.