Thread: Garmin edge 810

From the Garmin Support Center

My Edge is not recognized by my computer

Under some circumstances, your Edge may not be recognized as a USB device when you connect it to your computer or not boot it to the main menu. If this occurs, the device can be forced to activate mass storage mode so that it can be recognized by the computer and Garmin applications.

From the Garmin Website:

To force an Edge to activate mass storage mode, follow the following steps:

Disconnect the device from the computer
Turn off the device
Hold down the correct button:
Edge 20: START/STOP (Top Right Button)
Edge 25: START/STOP (Top Right Button)
Edge 200: PAGE/MENU
Edge 500: PAGE/MENU
Edge 510: LAP/RESET
Edge 520: LAP/RESET
Edge 605: Hold the tumbler up
Edge 705: Hold up the tumbler
Edge 800: LAP/RESET
Edge 810: LAP/RESET<--------------
Edge 820: LAP/RESET
Edge 1000: LAP/RESET
Edge 1030: LAP/RESET
Edge Explore 820: LAP/RESET
Edge Explore 1000: LAP/RESET
Edge Touring/ Plus: LAP/RESET
Connect the device to your computer
Wait for the device to be recognized by the computer (this can take 30 seconds)
If requested, install the USB control programs:
Choose "No, not now"
Click Next
Choose Install AUTOMATIC CONTROL Programs
Click Next and wait for the USB control programs to be installed
Click Finish
Release the button(s)
Sync history and update your device's software with Garmin Express
Click the appliance disc with the right mouse button
Click Eject
Disconnect the device from your computer
Turn on the device (wait for the software to be updated)

Your device is now working properly again.

Spoiler: Garmin Edge 810 keys

[Only registered and activated users can see links. ]