Firmware becker active 6 BH00

[radaadrian]

Hello colleagues, I also have a problem with a 6-inch becker active 6 model BE H00.
I changed the toch and I can't calibrate the new one
- I rewrote the FW, now it's in the windows interface
and I'm not connected to the PC _no required calibration at the beginning.
I clicked on this decalibrated display for a few hours and started calibrating windows. It says that it is already calibrated and to touch for salvage.
It doesn't let me touch corners like it used to.
Please have a Firmware that asks for calibration at the beginning.
Is there another solution to calibrate it?

Spoiler: image

[Only registered and activated users can see links. ]

Here is a picture of the motherboard. The display reacts but is very out of place. Is there any firmware that requires calibration on first boot that will run on this board,Becker active 6s CE

Thank you.

[Boki]

I'm pretty sure that display touch isn't the right one
Specify the model number precisely. I meant the label of the device (Becker active 6s CE, or whatever), not the plate

Good luck looking for ANY firmware

[Midnight Blues]

Moved to 'Discussions' section

[Rainerhohn]

I have 3 firmware for the Active 6 here, labeled with>
<BE6 BBF30 >
<PLUS BBF40 >
<Active 6 S Capacitive >,
sorry, no other Number for the last One, and there is also no discription in the NK.bin
Your Choise

Regards

[Boki]

Should be the third one ...

[Rainerhohn]

Ok
>This post requires you to click the "LIKE this post" button and hit F5 to read this content. < Active 6 S Capacitive
On your own Risk, don't Blame me.

Cheers

[fisching]

Run this utility and calibrate the screen.
[Only registered and activated users can see links. ]

[radaadrian]

Hello colleagues, I tested this FW, it installs ok
- the display responds to touch but is decalibrated
- I also tested other firmwares from other GPSs, but I didn't find any that would run. - when you install firmware on other gps, it usually asks for calibration the first time you use it.
This Becker model does not require calibration. - it is not calibrated even with its exe from windows. It seems that my display is not perfectly compatible with this board.
(Congratulations for your site I have a lot of information about gps and navigation systems)
Thank you.

Spoiler: images

[Only registered and activated users can see links. ]

[Only registered and activated users can see links. ]

I tested this exe with the help of windows commander,
I press several times in different places on the display until I reach the exe.
I don't have access to flash with a PC, so I can restore the internal memory.
He says it's already calibrated, don't ask me to press it in the corners. (see in the photo)

Spoiler: image

[Only registered and activated users can see links. ]

[Boki]

As I said:

I'm pretty sure that display touch isn't the right one ...