Google translation from:
The GPS software does not respond as I expected. General Problem Solution Document.
General Problem Solution Paper.
The GPS software is not responding the way I expected?
If you have the original CosmicSoft navigation software version 2, you always the best, the latest update to install this.
(The software version can be checked under the buttons "System More Settings >> Settings >> System Information ") The latest software often fixes several bugs that may exist on the various older software versions. A few examples are errors that occur suddenly at startup, the software starts and disappears was during the loading screen, streets are no longer found or countries disappear suddenly. The Update tool contains a few programs that the institution device memory retrieval where possibly corrupt / conflicting settings can sit that can cause interference. Instructions to install it: 1 . Download you click the CarTrek600CS3Update.exe file to your desktop by clicking the link below and choosing to save it as. (by saving to your desktop you will find it easier to back) CarTrek600CS3Update.exe 2. Close or stop only the Original meegleverde SD card plugged into an SD card reader on your PC. 3. Make sure there are no extra SD cards or USB drives connected to your computer. 4. Double-click the file CarTrek600CS3Update.exe and then following in the window that appears next. 5. Wait until the window indicates that the copy of the SD card is ready. 6. Then press Finish. 7. Remove the SD card from your computer / card reader and plug it into the CarTrek600. 8. Turn the CarTrek600 and then press the Navigate button. 9. There will now be a window appears informing you that files will be updated on the SD card. 10. While in this window, click the Update. Knob 11. Wait a few minutes until another message appears informing you that the files are updated. 12. Here click the OK button. The device will restart and you can use the new software now. * If you always get a recurring Update screen, you need the Read Write Lock button on the SD card is put towards the metal dots. After the Update or the failures themselves still
Manual / manuals / instructions. You can both hardware and software find the manuals for different types on our Download Section:My CarTrek 600 will not start, it lingers in the beginning / start up screen? How do I reset the device to its original factory state?
Device starts and stays in the black screen hang with the CarTrek600 Logo.
Below are instructions for resetting the device.
Please note that the device using a home charger or the USB cable is fully charged.
Please note that this document was created because it works and that maybe the instructions should be improved.
Please ensure that the unit is charged until the light is green.
Never remove data from the original SD card out, and format it never.
1. Download the linked file (s) below:
Download For the serial numbers in the ranges 327 471, 328624, 329584 & 331970
Download For the serial numbers in the range 325 603 & 326 715 (from 0 to 12,000)
Download For the serial numbers in the range 322 844, 326 715, 327 584 and 331 970
2. Place the extracted individual documents on the Root / Start from a blank or the supplied SD card via an SD card reader connected to your PC.
3. Insert the card into the device must be fully charged (light should be green.
4. Press the Standby button (top left) and hold.
5. Start the device on (even if it's not good unbootable) and keep the standby button pressed for 15 seconds
6. After about 12 seconds the screen will light up or flash again but this time with a progress bar.
(In case of newer devices, the screen will turn white or black remain)
7. Wait until it is finished and leave the unit turned on. This takes 15 minutes.
Restart or turn off the device during these 15 minutes.
The problem is caused because the device abruptly put off / was while saving settings *.