Welcome guest, is this your first visit? Click the "Create Account" button now to join.
Results 1 to 7 of 7
  1. #1
    Master JOYTURKX's Avatar
    Join Date
    Oct 2014
    Location
    UNDERGROUND
    Posts
    151
    Rep Power
    436

    new (Original BACK-UP) Navigon SEAT PID V2 7.16.8 Built 314

    [Only registered and activated users can see links. ]


    Navigon SEAT PID V2 7.16.8 Built 314 (Original Back-up) with speedcams + poi's
    This post requires you to click the "LIKE this post" button and hit F5 to read this content.
    Pass: 12345



    This is only software so download latest maps with nfs files

    Needed .nfs Files:
    BasicPhonemeFetcher.nfs
    Brunnel_EU.nfs
    CountryProfiles.nfs
    Landmarks_EU.nfs
    MapDrawer.nfs
    NavigonRealityView_EU.nfs
    PhonemeV3_EU.nfs
    poicats.nfs
    Terrain_EU.nfs
    TMC.nfs


    Note : This software now only on this forum



    Update Navigon Volkswagen UP 7.10.25 Built 2481 on this link:
    [Only registered and activated users can see links. ]
    Last edited by JOYTURKX; 13th September 2018 at 11:07 PM.

  2.    Advertissements


  3. #2
    Junior Member
    Join Date
    Sep 2018
    Location
    Denmark
    Posts
    1
    Rep Power
    0

    Lightbulb Thank you for the backup and solutions to my problems with the Navigon Seat Portable System

    Hello, thank you for the backup. I will tell you my story of updating the navigator.
    My car is Seat Ibiza 2014.

    The model of my navigator is
    Navigon Seat pid v2
    Version: 7.16.9 (build-314)
    Program: 141114-1302
    Garmin Würzburg GmbH, (c) 2014

    and before I updated it, I think the version was something like 7.14 or even lower, don't remember.
    First, I tried to update it through the Seat Fresh system on my laptop. The updates went okay and all the drivers were installed including something regarding the Bluetooth system.
    Then the navigator restarted a few times, and freezed in the start splash screen (where there is the Seat logo and three moving dots in the lower right corner). I tried to turn it on and off a few times but with no luck.
    Then I had to try the NAVIGON Fresh program that had an option for restoring my device. The program downloaded the files and tried to install them, and reported that they can't be installed. So, I was left with a navigator that had all of its contents erased and the Fresh program could not install anything. Later, I found out that the files were downloaded to a temporary roaming folder located (Windows 7) in C:\Users\^^USERNAME^^\AppData\Roaming\Fresh\Temp\NAVIGONFresh_tmp and I could find the files there, connect the navigator via USB and drag and drop the files, tada.

    What I actually did next was download this backup package of JOYTURKX. I dragged and dropped the files to my navigator via USB and it started working again. I also downloaded updated maps (2018) from another forum (one good place was [Only registered and activated users can see links. ]) and they also started working immediately. Just be sure that all of your map and data files are from the same version and year.

    The only problem I noticed was that voice commands were disabled on the navigator (they were working both in navigation and phone book before I did any updates). What I found out today was that the backup package was missing at least three files:
    Phoneme_EU.nfs = Responsible for voice control of Navis
    PhonemeV3_EU.nfs = Voice control (from MN 7.7.1 or higher)
    BasicPhonemeFetcher.nfs = For the voice control in the phone book menu.

    I downloaded all of these files from another forum (make sure they are the same version as your maps, both for example Q1 2018), dragged and dropped them to the NAVIGON "map"-folder, and my voice commands were back! Both in the navigation system and the phone book!

    Other problems I have had with the device + solutions:


    - The physical "voice command" button on the left side of the steering wheel (where there are buttons for volume control etc.) DOES NOT WORK unless an internal bluetooth system has been installed in your car (this usually costs extra and has to be done by a Seat manufacturer) ---> solution: this button is completely useless and CAN NOT BE USED with the Seat Portable System or the Garmin Navigon Navigator. The voice commands have to be activated through the navigator screen.

    - no "NAV" option found in the MEDIA button menu of my car for streaming music or phone calls via bluetooth with the navigator ---> detach the navigator (all parts!) from the car and connect them back while the motor is running and ignition is on. Make sure they are snapped tight to the car connectors. The NAV option should appear. Sometimes the navigator "resets" itself and the car can't find it for streaming, and if I detach it on purpose, then this has to be done once again.

    - poor voice or bluetooth streaming music quality ---> the navigator is most probably not properly attached to the car connector and/or the connectors are of poor quality. Try to move it a little with your hand so the connectors connect with each other, or you can detach it and connect again.
    Last edited by navigonseate; 8th September 2018 at 08:48 PM.

  4. #3
    Member
    Join Date
    Mar 2017
    Location
    serbia
    Posts
    9
    Rep Power
    0

    Default

    VW-SEAT NAVIGON 70/71 PREMIUM



    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    [Only registered and activated users can see links. ]
    Last edited by memilje; 18th July 2020 at 11:34 AM.

  5. #4
    Master apolyps3's Avatar
    Join Date
    Dec 2014
    Location
    Moitas City
    Posts
    164
    Rep Power
    244

    Default

    @memilje
    Its available version is Navigon VW UP 7.10.25 Built 2481
    Spoiler: Mirror VW UP 7.10.25 Built 2481
    Code:
    Please Login or Register to see the links

    VW_PID_V2_7.16.8
    and
    Seat_PID_V2_7.16.8
    [Only registered and activated users can see links. ]
    wtwaqAh

  6. #5
    Pro-Member kitos's Avatar
    Join Date
    Mar 2017
    Location
    In world
    Posts
    337
    Rep Power
    0

    Default

    Works for garmin for seat ibiza?

    Still freaze in seat logo.....
    If my comment was of interest to you or helped in finding the solution to your problem ...


  7. #6
    Master apolyps3's Avatar
    Join Date
    Dec 2014
    Location
    Moitas City
    Posts
    164
    Rep Power
    244

    Default

    It is garmin PID, uses navigon maps.
    It works with navigon maps, you should not use other software, because software updates are accompanied by a ROM update.
    It's simple to update maps, back up and update with Navigon Fresh Maps Q2 2020, [Only registered and activated users can see links. ].
    [Only registered and activated users can see links. ] is an example of how to do it.
    Last edited by apolyps3; 11th August 2020 at 09:46 PM.
    wtwaqAh

  8. #7
    Pro-Member kitos's Avatar
    Join Date
    Mar 2017
    Location
    In world
    Posts
    337
    Rep Power
    0

    Default

    Need software for repair garmin , the device is SEAT PORTABLE SYSTEM LIVE.

    """GARMIN NAVIGON (Garmin 10r-04 6953) <Q#:1002201> << Reference ID: 10487882K0 >>"""
    If my comment was of interest to you or helped in finding the solution to your problem ...


 

 

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •