Bigger font in notifications, in 2 lines if needed.
Spoiler: pics


Bigger font in notifications, in 2 lines if needed.
Spoiler: pics
@AnthonyGreek
I love your skin mods...
Generally, the system uses small arrows in the NextGen versions, whereas i used iGO Primo with bigger arrows.
QUESTION: Would it be possible to increase the size of the blue guidance arrows—or the directional indicators in the top-left corner in general?
Personally, i use it on a small-screen device; sometimes they look very small or are hard to make out from a distance while driving.
They look tiny, especially for long-distance guidance.
Even if I change sys, the DPI or base-DPI, the layout gets thrown off proportionally.
I'm using a maximum resolution of 1024x600.
Perhaps there's a way to customize them? That would be great.
Thanks a lot and for the trouble
Regards
Last edited by pbe2030; 1st October 2026 at 06:04 PM.

Hi. There is a way to increase them but there is no space since my priority is to make bigger distance fonts.
I have increased only the roundabout icons that were very small and there was enough space.
I could also increase the diricon to make space but then I would have to move all other things in cockpit.
So, sorry I can't do it.
Last edited by AnthonyGreek; 1st October 2026 at 06:14 PM.
@AnthonyGreek
Thanks anyway, and for doing what you could.
The worst part is the directions on long, straight stretches of road: the arrows become very small—like when it tells you to keep going straight for another 20–50 km.
It happens with both the basic skin and the Pongo skin.
I'll keep testing it and see how it goes.
Regards
1024x600 is "small" (low) resolution. The size of elements should be bigger, with higher resolutions the elements are smaller
Playing with dpi/base dpi has a big impact, but only if you don't go outside the frame of the screen's native resolution, then it doesn't change anything
I think you missed the parameter values, you shouldn't change the DPI, only the base_dpi
DPI depends on the physical size of the screen, for 7" for example it is ~170 (put 160 or 180). For 10" ~120
For the base_dpi, you have to experiment a bit. Steps +/- 10 or 20, start from 120 (for example)

Do as Boki suggests and when you find the right settings upload some pics.


A couple of small changes.
Bookmarks