Hi:
I have tried to delete the save folder, (actually
was the first thing I did) and configure it from the
beginning, and nothing. I use the arimi skin
I have tried with the most current skins (arimi/pongo) and I don't think it's a skin problem, I think it's more of an internal device problem but I don't know what the solution might be and the strange thing is that it only happens with iGO.
You have not understood me or I have not explained it well, I have tried to rename the "save" folder and use the arimi skin, as you advise me, and the problem persists, what I have not yet tried is with a basic skin because I do not know which is the right one
Hi:
I have tried to delete the save folder, (actually
was the first thing I did) and configure it from the
beginning, and nothing. I use the arimi skin
I really appreciate your help but to clarify the problem a little ...
The time of the device and the GPS are correct, the change from day to night also occurs when it corresponds, the problem is that when the change occurs, a message appears on the screen (as in the img) and the only way to remove it is to restart iGO .
Spoiler: img
NOTin real navigation
I have added these parameters to the sys.txt and the change from day mode to night mode does it without any error.
Note: I really don't know if all the parameters are necessary or only one of them is the one that fixes the error, but at the moment I will leave it like this.
Thanks for your interest, regards
Spoiler: sys.txt
PD: I hope that pepelu confirms that it works
Last edited by bruxco; 22nd March 2020 at 12:56 PM.
Hi:
I will try to add these parameters to sys.txt, when I finish the confinement for covid-19 in Madrid.
Thank you and best regards
I correct: the error continues...
The test had been done in simulation mode, when doing the test in real navigation the message continues to appear.
The change from scheme day to scheme night is done but the message "Loading iGO ..." continues to appear and the only way to make it disappear is to restart iGO.
Is there any other way to make that message disappear from the screen?
PD: I feel the inconvenience that it may have caused
Last edited by bruxco; 22nd March 2020 at 12:53 PM.
Hmmm. Add also this:
[interface]
exit_on_restart=0
[route]
allow_save_route=1
P.S.
If there can be some influence, here are the commands for:
Spoiler: power section in sys
One more thing:
whether the application has all the necessary permissions in the system?
Sorry to say it, but it doesn't work...the damn message keeps popping up.
I think I'm going to throw in the towel ... I'll have to manage by making the change manually
What do you think it could be?
What is strange to me is that it does not happen in simulation and it does happen in real navigation and that only happens in the HU.
PD: and yes, have all the necessary permissions in the system.
Last edited by bruxco; 25th March 2020 at 12:09 AM.
Bookmarks