Thread: Tried NG on MIO

Do you have any links where the software for WinCE can be downloaded, not the maps?

1) Why I cannot see/access the 1st page from topics below?
[Only registered and activated users can see links. ]

[Only registered and activated users can see links. ]

2) I would like to know if it is possible to install iGo Primo Nextgen on Mio C720.
Does anyone succeeded to install it? Any steps for that?
If not, then is it a problem of old, slow, limited hardware?
Do you have any links where the software for WinCE can be downloaded, not the maps?

3) I guess it is possible to install only iGo Primo on Mio C720, as I have seen some references on different forums, but I never tried.
Does anyone succeeded to install it? Any steps for that?
Do you have any links where the software for WinCE can be downloaded, not the maps?

I followed your advice and additional I have made lots of other tests.
Here is the result:
- Mio C720 works also with Primo, tested with version 9.6.13.405512, but is a bit slow and sometimes gives the bitmap load error. I installed minimum components on “content” folder and the maps have also minimum files as .fbl and .fda. I have also tried only 2D, no 3D buildings and other fancy things. It works, but is a bit slow.
- After the above experience I have never bothered to try Primo Nextgen on Mio C720, for sure is slower than that or even does not work.
- Then I have returned to iGO 8.3.5, which is faster and generally works.
- With both above, iGO 8.3.5. and iGO Primo, I have use the maps iGo HERE Q3 2017.
- I have installed also what you recommended, the “Cserrobi NaviSI Mio Cx20 Flash 1.0” package and is nice. I edited the .ini file to point to the right iGO .exe file and starts fine.
- The iGO was installed on SD card and Cserrobi was installed on Mio C720 flash.
- When I used iGO Primo, then I had to rename the Primo.exe to iGO8.exe, otherwise did not work. Probably more ini settings are needed in order to work with Primo.exe on SD card.
There is only one problem with iGO 8.3.5 on SD card and the Cserrobi, but maybe it has nothing to do with Cserrobi:
- If iGo 8.3.5 is opened and if I press shortly the “shut off” button, which behaves as a “standby” and then I start again, let’s say after some seconds, then the iG0 8.3.5 restarts from beginning.
Sometimes it starts from Cserrobi menu and sometimes from its own menu and sometimes a total reboot.
That is not normal.
- What kind of settings should be changed/altered in order to avoid that re-set when wakes up from standby?