Thread: Chinese 2 DIN radio/GPS, will not exit GPS mode

That's a good point. When I saw this in the OP:

"Now everything works great except for the GPS, when i power the GPS it logs in ok from a micro sd card (IGO pimo 9.6.13.405512) supplied by the seller with all the maps everything is all good, when i try to exit then the unit gets stuck on the exit screen ( igo screen with the message on the bottom right ''Exit, please wait'') and never exits."

I took that to mean that the unit came with Primo 2.4 on it when he got it - but maybe he actually meant that the vendor supplied it afterwards to *replace* what was on the unit originally... @newbeegps - can you please clarify? If Primo is NOT what was on the unit from the manufacturer, then as @orisis4isis said, it may be that this particular 2DIN cannot successfully run Primo 2.4 (and work fully)...

While most 2DIN units can run a "generic" version of Primo (no customizations for that specific 2DIN), there *are* a few 2DIN's that require a *customized* version of Primo to operate 100% correctly (not just sys.txt type customizations, but actual binary customizations). For example, the Rosen GM1010 2DIN unit works 100% with any WinCE GPS app - and any version of iGO8 or Primo - but the Rosen GM1210 2DIN unit comes with a customized version of Primo 2.0 that allows a few things to work that do NOT work with other versions of Primo (such as 1-use a speaker that is embedded inside the unit for the screen touch "beeps" - even in Primo, 2- causes the 2DIN clock to be set correctly from Primo GPS time (and there is no way to manually set the 2DIN clock), and 3-stops Primo from showing after starting up). If I put Primo 2.4 on the GM1210, none of those 3 things work correctly - regardless of the sys.txt options I tried to fix them.

So @newbeegps - can you please confirm what GPS app came on the unit from the factory?

Sent from my Vi10 Plus using Tapatalk