Likes: 
Unfortunately this method is not working. However I know the necessary settings (port, etc.) because the original Becker software is based on primo, therefore I can read it from save folder and/or data.zip/config/devices/becker_BSC10.ini. The TMC receiver is built-in the device, the car charger contains only the aerial for it.
I think, there should be some trick inside the navigator.exe or relevant dll files (ATMC_CE.DLL; AVQTMC.DLL; TMCGPS.DLL).
Welcome guest, is this your first visit? Click the "Create Account" button now to join.
Results 1 to 10 of 27
Hybrid View
-
22nd September 2013, 11:54 AM #1Member
- Join Date
- Sep 2013
- Location
- Hungary
- Posts
- 11
- Rep Power
- 0
-
22nd September 2013, 12:03 PM #2IGo Moderator
- Join Date
- Jan 2010
- Location
- Near
- Posts
- 174
- Rep Power
- 424
How did you know, not work, if you didn't try with iGO8 8.3.5? Check it, and then post results. It's not based on Primo, it's Primo. I know about original device .ini, but inside not always good structured command lines, and often problems and wrong values.
So, try what suggested with iGO8 8.3.5, if iGO8 doesn't detect it, then you'll have to use only modified original .exe, there is nothing special with that .dll files, it's built-in function inside .exe linked to communicate with OS drivers, so if that's part of OS and packed inside .exe, only solution is using original Primo Becker, sure modified to accept TMC licenses = .c.r.a.c.k.e.d PRimo Becker for your device.ﻻاله اﻻ الله محمد رسول الله
Reply With Quote
Bookmarks