That works great now, thank you.
Is there anyway to edit the plugin.ini to change any of the phrases? I always get access denied.
Thank you
I have made some more changes to the TTS messages, these are for the following messages;
Give Way,
Fixed Mobile Camera
Speed Breaker
Children
Dangerous Turn
Tunnel
POI
RPS Post
Dangerous Section
Black Spot
Road Closed
Congestion
Constriction
Low Visibility
Low Bridge
Hospital Zone
Fire Station
These can be tested in the test TTS menu to hear the message that is played. Attached are the files that make these happen, place the Voice_TTS-nua-eng-uk-f1-lua-dri40-vssq5f22 - v2.zip in the voice folder and replace tts-speedcam-eng.zip in the ux folder and the above should now be enabled.
I have been using nextgen for a few days now, I have noticed that every time it gives a camera warning it also says that you overspeed and the speed limit is miles without stating the speed limit value., plus it keeps repeating this message until the camera has been past. Its says the following for every camera warning:
"Warning! Speedcam."
"You are over sped and speed limit is miles"
Is this a bug? how can this be corrected to just announce the camera warning and to say it only once ?
Thx
Hello, it's strange. Perhaps it's related a tts voice? And do you tried to disable the overspeed warning? The other option if you want that the voice can't repeat the overspeed yo can add in the tts-speedcam-English.zip (inside the ux folder) to add in each speecam:
overspeed_min_speech_repeat_delay=-1
This sentence do the voice say the overspeed one time.
Remove this from sys.txt:
[warning]
say_camera_speed_limit=1
Instead of doing what you think it would do, it triggers the OVERspeed warning in dictionary.voice.
If you still want to use the sys.txt setting, then you can edit the overspeed warning to be whatever you want, but that will make it the same for all overspeed warnings regardless of circumstances.
A typical overspeed alert in dictionary.voice (that announces the speed limit) could be:
The speed limit is %s!="The speed limit is %s! Slow down."
Do not change or edit this.
Change this to whatever you want.
"%s!" reads the road speed limit.
Note that is you have more than one trigger phrase (the part before the =), the first one is used, and furthers ones are ignored. So always check first before adding.
You will have to compare your voice file/speedcam file zips with mine that I have made previously available here:
[Only registered and activated users can see links. ]
to find what the difference(s) may be. I have not compared. Mine works as expected (but I do not use the sys.txt speed for speedcam setting because I found it to be annoying). I generally mass copy/paste the entire dictionary.voice from a working copy rather than individually edit when converting a voice file.
Right now the last thing I am trying to solve is the "Read out Quick Detour" in the TTS settings, but it seems to be daunting...and I don't read Russian. ;-)
Bookmarks