Thread: Xero A1 and A1i software summary

Xero A1(i), Sensor Hub software version 5.70
as of May 25, 2018

Code:

Please Login or Register to see the links

(250 KB)

Code:

Please Login or Register to see the links

Xero A1(i) software version 2.80
as of July 2, 2018

Code:

Please Login or Register to see the links

(403 KB)

Code:

Please Login or Register to see the links

Changes made from version 2.70 to 2.80:
• Improved short range and steep angle pin calculations.
• Improved setup of new arrow profiles for A1i units.

Xero A1(i) software version 2.90
as of September 10, 2018

Code:

Please Login or Register to see the links

(403 KB)

Code:

Please Login or Register to see the links

Changes made from version 2.80 to 2.90:
• Fixed a potential lock up

Xero A1(i) software version 3.00
as of October 12, 2018

Code:

Please Login or Register to see the links

(416 KB)

Code:

Please Login or Register to see the links

Changes made from version 2.80 to 2.90:
• Fixed a potential lock up

Xero A1(i) software version 3.20
as of December 18, 2018

Code:

Please Login or Register to see the links

(417 KB)

Code:

Please Login or Register to see the links

Changes made from version 3.00 to 3.20:
• Added support for stalk mode. Stalk mode allows the device to remain on, but deactivates the trigger key to prevent errant presses. Stalk mode can be enabled by holding the power key.
• Added ability to hold left and right keys while adjusting a manual range.
• Fixed possible issue with no range given for steep angle cases.
• Fixed possible lockup.

Xero A1(i) software version 3.30
as of February 1, 2019

Use Garmin Express to install this file.

(417 KB)

Changes made from version 3.20 to 3.30:
• Fixed issue where a pin would not be displayed when targeting close to the max range.
• Fixed issue where the wrong maximum estimated range was displayed while manually adjusting the pin stack.

Code:

Please Login or Register to see the links