Quote Originally Posted by Donovan2123 View Post
Ok so once I have done all of the above then what do I do?
Then you tell me if your device works normally. If it still doesn't then we'll try something else.

Quote Originally Posted by Donovan2123 View Post
And you cure using that garminCure.exe and then flash using iinstaller correct?
I don't understand the question... To flash CURE/ORIGINAL firmware just select the corresponding option on GarminCure3 window, then press "Make Firmware", then press "Updater.exe" and the following window will appear:
[Only registered and activated users can see links. ]
If it doesn't appear, then use GarminCure3 from here: [Only registered and activated users can see links. ]

Quote Originally Posted by Donovan2123 View Post
And pre boot is just hold top left and powering on device whilst still holding top left of screen?
Quote Originally Posted by kunix View Post
To put your device into pre-boot mode, do the following:
1) Disconnect your device from the PC.
2) If the device is not turned off, then turn it off forcibly. You'd have to press the power button until the screen becomes completely black.
3) Press and hold the very upper left corner of the screen.
4) Press the power button and immediately connect the device to the PC and wait until updater.exe detects it.