Quote Originally Posted by devalian View Post
hi guys..

i follow your instruction and successfully converted my Garmin 1350 to SG/MY firmware. Version 3.10

i loaded with Malfreemaps 2012.10 with JCV.
i put the unlocked img into /Map
and JCV into /.System/JCV

yet i dont see the JCV from my garmin when i approach a junction. any advise?

P/S : instead of taking 3 GCD, US + PH + SG/MY. i only combine US boot.ini + SG/MY FW.bin. am i right this way?




No no...

I did not combine US+PH+SG/MY together

I did the 1st using US+PH, this does not crash the unit when a JCV is shown
but it gave me a error saying "The JCV for this map is not compatible with this unit"

so I use the original (US) boot.ini with all SG/MY FW all.bin from 1460 and this work flawlessly

Like Neil said
there is only places that show the JCV
you have to have the route for it to shows

for MFM map the JCV is quite comprehensive
I am from penang so if I were to set my location in the city center and navigate to the mainland, there is some JCV to show,
plus on the simulation run, pressing the top left hand corner (the distance to turn) would let you scan through all turns coming up, and those with JCV will highlight the lower "Junction View" wording
pressing that will show the JCV file associate with the Turn/Junction