Likes: 
I assume as you've posted in here that you mean you've loaded cure3 fw when you said 'It will go into preboot mode and it will take an rgn file from updater'.
The symptoms are the same as this 1490 [Only registered and activated users can see links. ] Try the fix referred to in post #12 there [Post #20: [Only registered and activated users can see links. ]].
Welcome guest, is this your first visit? Click the "Create Account" button now to join.
Results 1 to 10 of 645
Hybrid View
-
5th December 2013, 05:44 AM #1Garmin/GPS Systems GMod.
- Join Date
- Aug 2011
- Location
- Oz.
- Posts
- 6,570
- Rep Power
- 2534
'Thanking Posts' are banned. To thank someone, and/or to see hidden links and content, use the [Only registered and activated users can see links. ] button below left of the helpful post then refresh your browser [F5 key]. 'Thanking Posts' are banned.
Please don't spam. Posts serving no purpose other than to thank or to ask about hidden links are trashed or deleted, it's GPSPower's policy. Please don't spam.
[Only registered and activated users can see links. ] should make their first post as a new Intro Thread in [Only registered and activated users can see links. ].
-
5th December 2013, 06:51 PM #2Member +
- Join Date
- May 2012
- Location
- Too close to the New Madrid Fault
- Posts
- 27
- Rep Power
- 49
It will load the cure correctly in pre-boot, and the screen shows the loading function, and G7towin shows a change in firmware, but it will not get past the Garmin logo on reboot. So there is some other file corruption. RM USBprep does not see the drive.
AFter booting - it hangs at the Garmin logo and about every 90-120 seconds, it goes to a white screen and then reboots to the logo. So I am at a loss. It will not get to the point in the post you suggested above be recognized by the PC.
Reply With Quote
Bookmarks