Hi
I followed the instructions.
Everything went OK, including entering the preboot mode.
Then, when I pressed the OK button on the Updater.exe, the following message appears for couple of times.
Spoiler:
[Only registered and activated users can see links. ]


Then, after a couple of times, the following message appears. It appears that Updater.exe recognizes v3.2 of the fw in the device, and asks if I want to put an older version instead.
Spoiler:
[Only registered and activated users can see links. ]


When I press Yes, within miliseconds, the picture below appears, and it shows the bar to be full 100%. In the meantime, the screen on the device, first goes OFF, then shows LOADER text.
Spoiler:
[Only registered and activated users can see links. ]


Then, the next message appears saying that the update was successful, all the while, the screen still shows LOADER text, and is stuck on that. I remove the USB cable, and it still continues to show LOADER text. When I press the OFF button, the screen goes black (NOT OFF), and then goes off. If I press OK, the Updater.exe turns itself OFF, but, the screen on the device continues to show the LOADER text.
Spoiler:
[Only registered and activated users can see links. ]


When I allowed the device to connect to the PC, I found out that only 48 .bin files have been copied to the SD Card. All but 9 of them are “empty” (0 KB). Those 9 are of different size in KB. The file named 48.bin is the biggest, but its size changes with every attempt as Updater.exe tries to write to disk.
So, I decided to leave the device connected to Updater.exe even as the message reads that the update was successful, and even though Updater.exe has shot itself OFF. I am waiting for the LOADER text to disappear and/or something else happens to the screen for over 20 minutes now, and nothing new is happening.
The Update.txt file shows there are 255 .bin files to be copied, so, I decided to leave the device, and get back to it after a while. I will update afterwards.
Thanks for your patience.