Thread: Disable Nuvi Map Update Message

The pesky message "Your Maps Are Out Of Date"

This utility should help: [Only registered and activated users can see links. ]
Use it as follows:
1) Fully boot your device.
2) Press the battery icon until an engineering menu appears
3) Connect the device to PC
4) run start.bat by double clicking it

In case of success the utility will print a text similar to the following:

Code:
M:\WORK\GARMIN\[UTILS]\mupd-clr\Release>mupd-clr.exe
map update message remover v0.1 by kunix
Initializing USB...
hwid = 596
swvr = 490
name = n№vi 670 Software Version 4.90

Initializing USB once again...
removing the map update message...
all done

M:\WORK\GARMIN\[UTILS]\mupd-clr\Release>pause
Press any key to continue . . .

Originally Posted by tp2168

The pesky message "Your Maps Are Out Of Date"

This utility should help: [Only registered and activated users can see links. ]
Use it as follows:
1) Fully boot your device.
2) Press the battery icon until an engineering menu appears
3) Connect the device to PC
4) run start.bat by double clicking it

In case of success the utility will print a text similar to the following:

Code:
M:\WORK\GARMIN\[UTILS]\mupd-clr\Release>mupd-clr.exe
map update message remover v0.1 by kunix
Initializing USB...
hwid = 596
swvr = 490
name = n№vi 670 Software Version 4.90

Initializing USB once again...
removing the map update message...
all done

M:\WORK\GARMIN\[UTILS]\mupd-clr\Release>pause
Press any key to continue . . .

Tried it but no luck.

The start batch executed with some SetupInDev error after the Initializing USB line.

On the enginnering menu, the USB cable is shown not connected, although under normal mode I could read Garmin drive etc.

Any clues ?

I am using Nuvi765 with Windows 7.

Originally Posted by tp2168

1) Fully boot your device.
2) Press the battery icon until an engineering menu appears
3) Connect the device to PC

This is where things fall over for me: to connect to the PC I have to open the battery door, which switches it back into "Close the door" mode. When I connect the cable it goes straight to mass storage mode.

How do I get it to stay on when I open the door?