Thanks for the test map.
Could you give the coordinates of some problematic crossing points (or nodes) of the map, in addition?
Note: When checking this map for errors the MicroGIS Editor has found 109 errors of the Routing graph there, see the [Only registered and activated users can see links. ]
Incidentally, the "Verify Map" is available in the unregistered version of MGE too.
Last edited by Cnfhbr; 26th March 2014 at 12:09 PM.
Reason: added note
Hello CNFHBR
You can find on the Test_map2 some missing crossing points . [Only registered and activated users can see links. ]
This is the resulting img, decompiled with MapEdit. Wrong crossing points are located on road Identities: 376718 (1), 21792 (2) and 598331.
I use MicroGIS EDitor for Verify function but those kind of errors do not give any problems, I refer to White nodes and Roads not sliced at intersecctions, other ones I correct them.
I forgot one think.If you like to check mp2shp working with my map it could be useful to heve _types file, you can find here [Only registered and activated users can see links. ]
Wrong crossing points are located on road Identities: 376718 (1), 21792 (2) and 598331.
These roads are of the Type=0x13 in your source map.
This Type=0x13 corresponds to the GRMN_TYPE "CUSTOMIZABLE_ROUTE_LINE_7" in your _types file.
You should add this custom type of road into your _config file.
For example:
This is done, CRL7 is asigned to type 0x13 as one of the 7 customizable routing lines, and it works well in most of the cases, but there are some missing crossing points
You can see asignation on the _tipes file I sent on previous post. I think this is not the reson of the problem
Where is the CUSTOMIZABLE_ROUTE_LINE_7 and other your custom routable polylines there?
Therefore, the utility mp2shp believes that this polyline is unroutable.
Carefully read my post #24 above ...
Notes:
1. Do not use excessive Custom Roads, not all GPS-units support properly these roads during routing.
2. The _config file contains many important settings besides the above, place it in the installation directory of mp2shp, next to the executable file.
Hi CNFHBR.
Many thanks for your interest
I have changed file _config trying to follow your indications, see below new _config [Only registered and activated users can see links. ]
I do not know is there is something wrong but I continue with same problema.
Because of Reading again Readme fie , I do NOT all routing lines splitted at nodes because it is a huge work, but in mos cases it Works in some others no.
I have made a new test with Custom Routing lines splitted and no splitted, in both the cases it fails. See below the test, mp and resulting img [Only registered and activated users can see links. ]
New lines are on the righ hand side, if you like I can send you mu typ file to see it better.
Bookmarks