Thread: Converting JNX to raster IMG

Originally Posted by Swall

Sure. One technical question, if I may. Early you'd said that 36 seems the most suitable value for the MapSeries parameter for raster maps. But the map product I'd mentioned uses 23 instead (assuming the generated report is correct). Can you approve that deviation?

ProductId <> 36 means some of the vector information from other maps - for instance, roads and POIs - will be visible above the raster.
This also changes the way the map's layers are distributed by the zoom levels in the device, the distribution becomes dependent on the device's detalization settings.
Perhaps, if you change the detailization to the max level, the map will become visible at the zooms below 200m.

Originally Posted by AlexWhiter

ProductId <> 36 means some of the vector information from other maps - for instance, roads and POIs - will be visible above the raster.
This also changes the way the map's layers are distributed by the zoom levels in the device, the distribution becomes dependent on the device's detalization settings.
Perhaps, if you change the detailization to the max level, the map will become visible at the zooms below 200m.

You're right, the map detail setting affects the visibility at max zoom levels (at the cost of slowing the device down). Now the misalignments are more apparent. But all the four layers (including 1:50000) are present, I did not noticed that initially. Out of curiosity, the only way to get more information about the MapSeries parameter is to install MPC and read the help files and to experiment, right?