It's work on all 1xxx
dont work for mi nuvi 12xx
It's work on all 1xxx
@Fabio Miguel
try this:
turn nüvi on, enter diagnostic mode by pressing battery icon for 5 seconds and then connect USB cable to computer.
Hold the power button, immediately as Garmin logo appears, press upper left corner
You have to navigate to get to the good.
Galaxy S5 Kitkat 4.4.2 / Nuvi1200->1250 / Nuvi3790T->34xx / Nuvi 2200 / Nuvi 66 / Oregon 600
It worked for me on 37xx. Thanks
i try to enter pre-boot on my nuvi255w. but did not manage to enter it. please guide me on it, i tried by pressing upper left corner and press at RM area. but failed.
Yeah, unfortunately absolutely same here with the 1350. It does not boot (after a map upgrade) - only "loading maps" appear but for hours w/o any success. Also tried upper left corner and "RM" area for pre-boot but nothing happens. After a while it get me few times to calibration - but that is all - no menus, no anything. Cure 3 has a grey "USB port", only "COM ports" is active - so no chances with it too
For Nuvi 13xx 14xx do this.
Make sure that you have loaded Garmin Drivers on the Windows Computer.
Start Updater.exe
Make sure that the nuvi is switched off.
Plug usb cable into the computer but not into the nuvi.
Now place your finger on and hold the top left corner of the screen with the nuvi still off.
Plug in the usb cable. It should enter pre-boot mode now. (Ding Dong)
If it doesn't happen try inserting a memory card or removing a memory card and try again.
Another trick that seems to solve some issues on 13xx 14xx is holding the power switch down for longer than 30 seconds and then plugging in usb cable.
Let me thanks first!
Which one Updater.exe you do mention?
The Ding-Dong never happened unfortunately. There is a short period (few seconds) when it appear in Windows but the Cure 3 failed to update/cure it. It does not happen every time but few times when I've tried to pre-boot it. Most of the times it does not appear. sh*t
Bookmarks