Hi guys, I have a radio wince 6.0 model: F6002B 52Wx4, I have the igo, and when I enter a route, the arrival time section is late, however the time of the radio and the area IGO time is well configured, using GMT +2. For the country where I am (Spain), apart from that, I have configured the time zone of the radio (where you adjust the navigation patch), to GMT +2 and it also shows the time well ...
Which may be?
Any solution?
Spoiler: images
If my comment was of interest to you or helped in finding the solution to your problem ...
Only solution for you is to find new firmware or patch for your device which could fix this issue caused by WNRO. Good luck with that
Yes... I go to try the fix for igo:
[regional.timezone]
reset_os_timezone=0
sync_os_timezone=0
sync_time=0
if not works, i try to update the FW WayteQ x980BT
If my comment was of interest to you or helped in finding the solution to your problem ...
[timezone]
patch_dst=1
sync_time=1
use_auto=1
sync_os_timezone=1
reset_os_timezone=1
[timezones]
use_timezone_setting_fix=1
use_new_timezone_ini=1
timezone_key="Time Zones"
[debug]
sync_time_with_local_time=1
Did you tested it?
Last edited by Boki; 1st September 2020 at 09:38 PM. Reason: removed unnecessary quote
If my comment was of interest to you or helped in finding the solution to your problem ...
Hi All!
@Kitos
Where is the WNRO project going?
Would this work with My unit? It's a 7021g.
Hi All!
RDavidson,
Describe the system details, I will try to find the right patch package
I checked, this multimedia is not characterized by a WNRO error, it may be just a simple setup task. Please check.
Last edited by vaczak; 16th November 2020 at 10:20 PM.
Bookmarks