TomTom One v2 New Edition - Navcore Problems

[bobnoe1]

Hi All, I have a TomTom One v2 and have tried using the v8.410 navcore and I'm having a few issues

It initially works but when I switch the TomTom off, it won't switch back on until I remove the SD card and refit it.

Sometimes the POI alerts don't have sounds.

Also, the TomTom shuts down after a 10 second count down if I don't operate it. Is this ok?

Any ideas?

Cheers

Bob

[P33dro]

Hi All, I have a TomTom One v2 and have tried using the v8.410 navcore and I'm having a few issues

It initially works but when I switch the TomTom off, it won't switch back on until I remove the SD card and refit it.

Sometimes the POI alerts don't have sounds.

Also, the TomTom shuts down after a 10 second count down if I don't operate it. Is this ok?

Any ideas?

Cheers

Bob

go here
[Only registered and activated users can see links. ]

select
Navcore 8.544.1838 - 32MB
or
SE Navcore v9.101.516023.2 - ONE

update autoactivate before try activate

Check SD format is FAT32, and check bootloader version...

also check this if needed
[Only registered and activated users can see links. ]

[bobnoe1]

Thanks for the advice P33dro

[bobnoe1]

Here's my results after a few hours of playing with navcores (following the tutorials)

I'm running v885 Uk and ROI maps for all:

Navcore 8.410
Initially ok but then becomes a bit erratic - loses sound on POIs, shuts down by itself

Navcore 8.544.1838
Boots into the menu but then locks up until hard reset is performed

Navcore 9.101.516023.2
Gets to splash screen and freezes

Original Navcore 7.903
Runs perfectly - will leave the device like this