I've always had problem with my truck sat navs, when I first buy and use them, they work fine, using sd card 32gb with
igo map already installed, I use sat nav normally and keep favorites addresses on sd card, after a while (12-18 months)
I get a message saying
'Program memory is very low. You must select one task to close, or increase the amount of program memory, if available'.
I don't know how to increase the memory.
This goes on for a few times until the unit will not load the sd card with map, so I cannot access my favorites, which I have around
300 addresses, so I normally buy another sat nav with its own supplied sd card (with maps installed) and start again inputting
the customers addresses into my favorites, I don't understand what's going on, as I thought that a 32gb card would have enough
storage for my favorites, I am currently running my sat nav with its own flash memory and map and putting addresses into that
memory, the map isn't as good as the one on the sd card, plus I don't know how long it will be before it's full, assuming that is what the problem is.
I do not use the sat nav for radio, pictures, films, or anything other than the sat nav bit.
I've tried to go on 'naviextra's toolbox', but cant get anywhere with it, I would like to be able to transfer favorites from sd
card to new satnav (one that runs igo primo), but don't know how to do it. I have plugged in sat nav to laptop, but nothing
is intuitive, like 'Find favorites', drag and drop to a folder, plug in new sat nav with sd card and drag and drop favorites
onto it. I'm not savvy with file editing,
Give me an engine to strip, measure, rebuild, tune, dyno it remap it, and I'm on it, but this stuff, I cant get my head round it.
Any help would be great.