Thread: Chinese 2 DIN radio/GPS, will not exit GPS mode

Very seldom do you get "original" when from chinese, most are clone hardware with "stolen" proggy on it. They will try to make it "fit" and "work", but not always successful (cost of cheap pricing.) From looking at the codes so far, it looks like it's a Primo version with lots of codes copied from other products. There are lots of "profiles" for devices (even android ones) If you buy say Pioneer directly* from them, the proggy (Avic) are made/tested for that unit (people posted it and everyone assumed it's for any devices) so there are functions that won't work when not used on the Pioneer unit (lots of "useless" codes)

* They have license and support from NNG to use their proggy

@ jtrosky: yes, I agree with you, you are generally right. But. This thread have many stories, many doctrines without results. Reduce.
Device problem is third option.
I also deal with 2din devices for a while, and I know why I said to him try with clean package.
- it needs to do to exclude the potential software problem. SD cards are cheap, take a new SD card and try
Second thing: for mostly of WinCE device, I have problems with ESX package, but that package works excellent for VW based clones.
- That's why I recommended him to try ESX if the first solution does not pass
Third thing, if previous two solutions not works: device software. It require a particular type of software or a very specific setting. Launcher is the main culprit.
Let him try, and let we wait for his response.

Run the proggy posted at [Only registered and activated users can see links. ]
and get the value of keypress for each of those buttons.

??
I don't know what you have done
Just downloaded it, opened it, everything is there:

Spoiler: pic

[Only registered and activated users can see links. ]

Originally Posted by newbeegps

...
Boki_Srb, can you let me know where i can find this ''package adapted to such device. Primo ESX 9.6.5.278914.''
A direct link would be greatly appreciated.
...

Here it is, fresh uploaded:

Spoiler: dl

This post requires you to click the "LIKE this post" button and hit F5 to read this content.

P.S.
Sometimes, you just have to try several versions.
If this don't work, good versuion is also 9.6.5.306142, not dedicated, but who knows...
Always try with clean setup on clean SD card, they are cheap, that you receive from the seller leave aside.
Btw, what is exact model you have, ALYVAT VW-6501 precise?
I read several feedbeck from other buyers, all complain of the same problem. So, it is up to device, let see if can be fixed.
If Primo definitely stuck, try with NextGen:
[Only registered and activated users can see links. ]
or
[Only registered and activated users can see links. ]
or
[Only registered and activated users can see links. ]
or, you can live without exit button Just turn off device.

Originally Posted by jtrosky

Is there any chance that if you hold in the Navi button for a few seconds (instead of just pressing it) that it will switch between the Navi and 2DIN functions? I still say that we need to find a way to switch between 2DIN/Navi. Or maybe try holding in the Radio button while in Navi to switch back to 2DIN? Just trying to think of some other possible ways to switch back and forth....

Sent from my Vi10 Plus using Tapatalk

I was wondering about that as well; but I think if the keycode of the button pressed can be determined, then proggy might be able to be config to do something with it. This is why I asked the proggy to be run and keycode collected.