I was testing both Becker 9.6.8.265850 and 9.6.8.247703 recently on my Wince 6. However I can't have 3d car or even don't have simple navigation arrow appeared on the map.
Moreover the radio will stop every few seconds without any sound until I need to touch the screen then the sound come alive again. But the sound stops again a few seconds later. I have to keep repeated touching the screen in order to have the sound.
Is this something to do with any Sys.txt that I need to input?
28th September 2020, 06:05 AM
Boki
No, it is something up with your unit
Use "standard" Primo
4th January 2021, 09:26 PM
EvaTs
Hi, I have question about favorites icons.
When u look map without navigate, its ok, but if u look map with set destination, u can't see yours favorites. I think is in sys problem..
For who may be interested in disabling the volume slider (if accidentally you click on the icon of volume it activates the ding and os keys) I put in sys this:
[interface]
volume_slider=0
So when Primo starts the volume slider is not active anymore. I chose this because when I already set the volume mode I want to stay so without changing by accident.
18th March 2021, 01:03 AM
lakisdj
What adjustment do I make so that the plane does not go out in navigation. I have a 3D and it changes alone on the plane. I only want 3d !!!
Try to be more precise and understandable in your expression, use a translator
16th April 2023, 10:43 AM
ThunderRat
Unsure if this is an iGO Primo issue or my xgody firmware but when i switch the car off the sat nav turns off. Is there a line for sys.txt to put it in standby and when i power up the car again it will go back to where i left off. Looking for easy fix rather than rewiring my power socket
I did try below line in the hope it would even stay on as this change to just more convenient for when i stop for fuel or the likes.
...the fault lies with the software of the car of course, it can be done if you have previously downloaded the system to the radio and previously removed the settings in ini, otherwise you can't do the same with stationary devices
16th April 2023, 10:28 PM
ThunderRat
Sorry i should have said. This is a stand alone unit plugged into the 12v power socket
16th April 2023, 11:50 PM
k1w1_123
@thunderat
These settings work for generic WinCE devices running Primo, allowing them to sleep on power off and resume when power is restored. I am not familiar with XGODY but from looking at their specs online I think its pretty likely this will work for you although the device settings screen could be hidden.
Settings/Navi Path/Auto run GPS when startup - OFF
Settings/Next/Auto Start - OFF
****************************************************
BLUETOOTH
Using these settings, the Bluetooth function doesn't resume when the device wakes from sleep, so if you are using Bluetooth the device settings must be
Settings/Navi Path/Auto run GPS when startup - ON
Settings/Next/Auto Start - ON
The device settings remain the same and you have to live with a full reboot which takes a bit longer