D1340-50 is correct.
Your Basemap is quite old mine on 1300 is version 5.01 yours is only 2.00 (Off topic but you should upgrade it now)
Show us dir where you have your JCV files ?
Your nuvi is not seeing the JCV files in the Inventory
13th October 2013, 12:41 PM
Kova78
Thank you for the reply :)
First I put the JCV in the /.System/JCV/ folder and I noticed that the JCV were not displayed.
After I put the JCV file in the SD:/Garmin/JCV/ folder...nothing...it doesn't work.
Both those locations are OK for JCV
Make sure you are not typing JVC instead of JCV lots of us make this mistake more than once. (check again)
JCV must show up in inventory. (Next line after Time Zone Map) (Check again inventory)
Even if the JCV is the incorrect one for your Map it will still show up in Inventory.
13th October 2013, 01:04 PM
Neil
Sorry, the 'B' was a typo. The important thing is the suffix: '-50'. That means JCV is enabled as is SLI etc. Your original splash was D1350-00. There is NO JCV file listed between the Time Zone map and the Splash lines. It should show a line starting with 'JCV' and then further info. If it's not there in your Inventory then as dasilvarsa said the JCV file is not being recognised for some reason even though the file path is correct and it's actually enabled on the device. That only leaves the file. So if the JCV version matches the map version that it's teamed with and the file and folder are correctly named, then maybe the file itself is corrupt.
The final question is have you hard reset or cleared Non-volatile memory on your unit?