Navitel E707 Magnetic - alternate software (firmware) to run iGO Primo

[janch]

Hi folks!

I recently dealt with NAVITEL E707 MAGNETIC, trying to run iGO Primo on it. Unfortunately, that was not possible because the device and original Navitel software runs on Linux OS, therefore I hit the wall. Anyway, I found the firmware that transforms the OS to standard WinCE with the generic menu from where you can run any standard WinCE-based navigation. I installed iGO Primo which runs perfectly on that device with 256 MB of RAM and a 7' display.

Spoiler: link

This post requires you to click the "LIKE this post" button and hit F5 to read this content.

Extract and copy all files to an empty fat32 formatted SD card. Insert the SD card, power ON the device, and wait until the installation is finished (about 3-5 min). After it's finished, remove the SD card, otherwise installation will start again on the next power cycle.

[Only registered and activated users can see links. ]

Enjoy!