Answer
Spoiler: .
Hi all,
I have a problem with my TMC config in the UK. Basically it is only downloading TMC data local to my location and doesn't apply traffic for long journeys.
For example if I delete my save file and have location defaulted to the centre of London, traffic data is downloaded for London. If I get a gps fix and route from my location to London it applies TMC and adds 15 minutes on for London traffic.
If I then close Igo and launch the app it only loads traffic local to me.
If I route to the same street in London the time will be 15 minutes less, i.e TMC data there was never used.
How can I make IGO download TMC data for the entire country or at least download more TMC data for the route I am going to take?
I am using iGO Gift 9.18.27.687519 - 26.jan.2017
Current sys config:
Thanks[http]
enabled=1
[tmc-http]
enabled=1
start=1
servers.size=1
servers[0].url="http://zippy.naviextras.com/services/tmclite/data/nng-igo-tmc-iphone/0/"
dt_dl_0=300.0
;refresh in sec
dl_dist_0_km=100.0
;radius in km
profile_name="nng-igo-tmc-iphone"
;profile_name="nng-igo-tmc-igoworld"
;profile_name="nng-igo-tmc-jci"
;profile_name="nng-igo-tmc"
profile_version=2
udp.enabled=1
[tmc.src.http]
enabled=1
[network]
available=1
Last edited by gpspassiont; 20th January 2019 at 01:04 AM.
Answer
Spoiler: .
Last edited by osiris4isis; 20th January 2019 at 01:58 AM.
Do not PM me with questions. That's what a forum is for.
Thanks so much, will test this out tomorrow.
I assumed those setting were for something different as I can't understand why they are set so low unless to save data.
Probably because it slow down the proggy. Limiting the area, time and lossy transfer makes it faster.
I just realized that for NextGen, you need
Spoiler: .
Last edited by osiris4isis; 20th January 2019 at 04:49 AM.
Do not PM me with questions. That's what a forum is for.
Hi,
Are you sure about removal of
TMC is unavailable when this part is removed.servers.size=1
servers[0].url="http://zippy.naviextras.com/services/tmclite/data/nng-igo-tmc-iphone/0/"
Thanks
You are using NextGen, so "servers" settings are not needed (they are for iGO/Primo). You need to have the other settings indicated in my previous post.
Do not PM me with questions. That's what a forum is for.
Bookmarks