Any help please
Dear friends I tried a version of IGO NEXGEN after I returned to my version 9.6 of IGO but the problem I have no GPS signal, I tested it gives me Scan GPS Port 2 Baud 4800 so that before I had Port 2 baud 9600 how I can restore the initial baud thank you in advance
Note I have wince 6
Last edited by ABBASS; 15th February 2016 at 07:57 PM.
Any help please
Software cannot change physical address of port and it's baud rate. Problem is probably at other side.
Clean your device (we don't know what is it) from every of the rest of the new version (we doesn't knows what was original version), also everything from it. Then try with good proven "old" version.
Bookmarks