thanks,will they show up in my unit as garmin Cyclops cameras,in my cameras?
I appreciate your help
Last edited by dasilvarsa; 18th November 2012 at 02:18 PM.
The difference between stupidity and genius is that genius has its limits.
is that a definitive answer then my friend ??
they wont work on my nav
If you placed Cyclops cameras file into folder "poi" on your device let's try to find it in menu "About" or try it in driving (or in GPS simulation mode).
Garmin Cyclops™ Safety Cameras - EU / AU / NA /SAf /RU (November 30. 2012)
File contain Original & UnLocked filesCode:Please Login or Register to see the links
November 30. 2012 ALL Countries Updated except South Africa...
[hide][Only registered and activated users can see links. ][/hide]
click on LIKE to unlock links
Would like to inquire if anyone has got the Cyclops files to work on a Kenwood DNX receiver that includes Garmin GPS? The unit seems to load the file, but when you approach a red light camera, the unit either reboots or turns off for some strange reason?
I think these Cyclops dont work on Kenwood units, you can try to use Sox.exe.
In order to get sound alerts you have to put the sox.exe file in the same folder as POI Loader is run from.
After un-zipping Sox.Exe file, go to Program Files, Garmin folder, and then the POI Loader folder. Place sox.exe there in the same location where PoiLoader exe is located.
Not sure it will work and probably depends on you kenwood model too.
Take a look to the procedure to load them here:
Code:Please Login or Register to see the links
@ great Caty
Sorry...but sox.exe not works with Cyclops : files previous compiled GPI
File GPI not works with PoiLoader
@ Red Flame
The strange thing that some users write that Cyclops work well with others not DNX ...
Try to do so ': in myGarmin, try to buy a pack of Cyclops (for your country) and see if they give you the compatibility with your model.
Then delete the purchase
NOTE: Update firmware your DNX: SO navigation Garmin and SO DNX
I tried to purchase the software and it installed the Garmin plug-in for my browser and it asked me to then plug the unit into the PC. Kenwood eliminated the USB interfaces in the back of the DNX series after 2011, so there is no way for a PC to communicate through USB to the Garmin software in the 2012 model. 2011 models have such a interface. So I take it that means they no longer support it. Also for 2012, Kenwood decided to eliminate all the voice alert features for POI that worked on prior years. They replaced it with a single tone or continuous tone. It was a big mistake IMHO.
I think it would work for 2011 model, but I do not have one to try.