Does your PC detect the device as a mass storage in that TEST MODE?
Printable View
Does your PC detect the device as a mass storage in that TEST MODE?
it detects it before enetering mass storage , yes also when entering test mode
I didn't understand this phrase. Can you clarify?Quote:
Originally Posted by mylona79 [Only registered and activated users can see links. Click Here To Register...]
So, when your device is in TEST MODE, your PC sees it as a mass storage device (a flash drive with GarminDevice.xml and stuff), right?Quote:
Originally Posted by mylona79 [Only registered and activated users can see links. Click Here To Register...]
yes very correct
Ok. Probably your device can't be put into pre-boot mode by pressing buttons.
Here is another possible way:
1) Disassemble the device and find 4 pins which are similar to 4 pins (inside red circle) on the photo:
[Only registered and activated users can see links. Click Here To Register...]
2) Short circuit the pins which are marked with the blue line.
and how will i proceed from there on ? when i short cercuit the twoo pins i will assemble and then ?
if i remove the car battery would it do the same job or no ?
I don't know what will happen if you remove the car battery.
Have you found those pins already? Can you post a photo here?
To enter pre-boot mode, just short curcuit those pins and turn on the device (you should know how to turn it on).
ok when i do that i will inform you
is there onother way to flash firmware because its very complicated to open ...
I don't know any other ways. Maybe someone else can help.
do you know a way with mass storage ?