Becker transit 70 tmc

**Boki** · 3rd September 2017, 02:33 PM

Ok. Put all needed files in root of igo folder.
Your TMC port is 5, but there is no baud info. I guess it is 38400. Do experiment. Adapt sys.
Delete save folder, and start Primo again. Of course, connect TMC antenna

**tomik88** · 3rd September 2017, 06:30 PM

Ok, so what can i do exactly?what have i in sys.txt according you?and data.zip can be from original software or must be from downloaded igo primo?

**Boki** · 3rd September 2017, 07:03 PM

Original Becker software is actually different version of Primo, and data.zip is intended for it.
Also, it is highly adapted to Becker specific look and functions. Only for that. You can not use it for "ordinary" Primo. Btw, you can not even mix Primo 2 and 2.4 datazips.
Just put in sys section all parameters for tmc, including port and baud values. Be sure that you have all needed files.

**tomik88** · 3rd September 2017, 07:19 PM

ok i understand.if i insert tmc setting from original becker primo (data.zip/config/devices/becker_BJE_Wifi.ini)

[tmc]
setup_hw_immediately_on_hw_ok=1
use_starter_thread=0
tmc_info_database_on=1
source="avanteq"
port="COM,5"
internal_tmc_name="avanteq"
tuner_model= "IGO_GPSTMC_TUNER"
update_ltn_on_country_change=1
ignore_suspend=1
ignore_resume=1
internal_restart_timeout=15000
tmc_health_polling_timeout=1000
rds_health_polling_timeout=1000
avanteq_source_used=1
hwrestart_on_acc=0

so i have not tmc icon on display,i can only turn on tmc by wifi i need to add some to active tmc by MHz

**Boki** · 3rd September 2017, 07:27 PM

Try also this:
Unpack this file and put content in root of iGO:

Spoiler: attach

Btw:
What exactly happen if you add values from janch post (#2)? But, of course, change value for port from 1 to 5, and add baud rate in it. Mix values, change NMEA_GPSTMC_GNSPORT to IGO_GPSTMC_TUNER...

**Boki** · 4th September 2017, 09:07 AM

If you still have problems, in next thread there are crc*ed versions in last posts, updated fresh links:
[Only registered and activated users can see links. ]

**tomik88** · 4th September 2017, 04:09 PM

if i insert from janch post, navi showed tmc but it was not find a tmc message = no tmc signal
and if i change NMEA_GPSTMC_GNSPORT to IGO_GPSTMC_TUNER, it doesn ot show tmc icon