Licenses are not important at all in your case.
But a couple of my acquaintances already complained about routing with HERE maps in this part of Europe.
Printable View
Licenses are not important at all in your case.
But a couple of my acquaintances already complained about routing with HERE maps in this part of Europe.
which map you think is the best for trucks ?
Question is simple, but answer is not!Quote:
Originally Posted by salonika [Only registered and activated users can see links. Click Here To Register...]
Specially without any information, and my crystal ball is foggy today ;)
[Only registered and activated users can see links. Click Here To Register...]
I once saw in a list of sys.txt commands:Quote:
Originally Posted by salonika [Only registered and activated users can see links. Click Here To Register...]
[defaults]
mainroadness=60
and I took a note to one day try playing with different values to see if it had any effect. You might like to experiment and let us know what you find.
Boki_Srb answer to you and he is right.Quote:
Originally Posted by salonika [Only registered and activated users can see links. Click Here To Register...]
To solve problem try:
1. Check out settings of :Truck Settings in menu.....height, wide,how long is it....
2.Uncheckoffer congestion route on highways in Route Settings......if you have this checked...depending of your travel hour, primo read historical traffic from smart file....think out ....this cause problem to you.
3.Try to change map...older version....as boki wrete.
edit 2!!!!
Hi,
I use MIO Spirit 680 with WinCe 6 and IGO Primo Europe 9.6.13.405512 whit resolution of 480x270.
I would to improve the size of the alphabetic characters of streets in balloons, with mapfontscale3dframed in sys.txt, but he not work.
Searched in the post I find:
[3d_config]
disable_roadsign_navigation_mode=0 ; =1 [balloons]; =0 [in street]
roadsign_always_framed=1 ;(0) always name balloons
roadsign_bitmaps=1
but he not work.
Is there anyone who knows the solution?
Sorry for bad english
add this in sys.... change "203" to high or low letter road;)
[interface]
mapfontscale=203
mapfontscale3dframed=203
OK for high or low letter road, but street name in the balloons have a constant font size.
I suppose is default setting. I try again.
[3d_config]
disable_roadsign_navigation_mode=0 ; =0 [balloons] (name street in balloons); =1 [in street]
roadsign_always_framed=1 ; (1) always street name in the balloons
roadsign_bitmaps=1; 0 rectangle frame, 1 rounded rectangle frame
As @arslankayna suggests, add the following to your sys.txt:
[interface]
mapfontscale3dframed=203
then play with different values, for your resolution I would start at around 100 rather than 203
Note: this will change the size of framed street names and other names like suburbs, streams etc., but ONLY when you have
[3d_config]
roadsign_always_framed=1
in your sys.txt
I hope this is clear for you
papino,
Try this:
[3d_config]
roadsign_lines_per_screen=16 ; (increase or decrease until satisfied)