When you run procedure over SD, do you have something writen in update.log?
Forget about cloning, you won't get any help with that here as catymag said. That's not what i was referring to in my previous post suggesting you may need help to repair your unit's NV if it's damaged. Don't post your email address either, it's against forum rules. I think that the unit cannot read the SD maybe. Was there anything in the file update.log in the 0827 folder?
'Thanking Posts' are banned. To thank someone, and/or to see hidden links and content, use the [Only registered and activated users can see links. ] button below left of the helpful post then refresh your browser [F5 key]. 'Thanking Posts' are banned.
Please don't spam. Posts serving no purpose other than to thank or to ask about hidden links are trashed or deleted, it's GPSPower's policy. Please don't spam.
[Only registered and activated users can see links. ] should make their first post as a new Intro Thread in [Only registered and activated users can see links. ].
Thanks for the heads up about the forum rules.
on the SD cards - Garmin - Updater - 0827 there is three folders
- idr.bin
- update.log (0bytes)
- update.log (ergn.48, fftl,0,1:/2.bin, reboot)
Ok, the command didn't run. So the unit does not enter into the boot process long enough for the task in update.txt to be recognised. If it did, there would be a report in update.log.
'Thanking Posts' are banned. To thank someone, and/or to see hidden links and content, use the [Only registered and activated users can see links. ] button below left of the helpful post then refresh your browser [F5 key]. 'Thanking Posts' are banned.
Please don't spam. Posts serving no purpose other than to thank or to ask about hidden links are trashed or deleted, it's GPSPower's policy. Please don't spam.
[Only registered and activated users can see links. ] should make their first post as a new Intro Thread in [Only registered and activated users can see links. ].
ok i will go get the other nuvi quickly and try that
i just tried with the display with the working unit, the bricked unit behaves exactly the same with the display from the working unit, i also tried the display from the bricked unit on the working unit and the displays both are ok.
what next...
This mean that display work Ok.
Try this one more time.
Extract rar from Caty post on your empty SD ( you will have only folder Garmin on SD )
Disconect nuvi from Pc and make shure that your nuvi is turned Off
add SD in your nuvi and lock screen with button
now connect nuvi to Pc and nuvi will turn on
if command from SD work your nuvi will turn off and turn on and go to mass storage ( look if you have something writen in update.log)
if update.log is empty, try again with SD inserted in nuvi but this time create procedure for pre boot ( hold screen of nuvi etc )
Try this.
Flash GarminCure3 in original mode not cure mode.
Then do Caty Package as instructed above by Loly.
You cannot run commands from SD while Cure Firmware is loaded.
The difference between stupidity and genius is that genius has its limits.
Albert Einstein.
I am lost with this unit seriously i have tried each and everything everyone has suggested to me but still no joy. the two pictures attached, on the first picture as mentioned before it just shows that garmin logo then reboots continuously, it doesnt even show at the bottom of the screen loading maps nothing just that garmin logo.
Bookmarks