Is it possible for a firmware first patched with Universal Firmware Patcher to be then patched for .jnx files ?
sorry for a little off-topic but I just can't figure it out how to enter in pre-boot mode on Edge 1000. I have tried almost every combination with all 3 available buttons..What I have tried:
drag patched.rgn into updater.exe and tick USB than:
- power off garmin than power it on while holding lower left button than connect USB...nothing, garmin goes into mass storage
- power off garmin than power it on while holding lower right button than connect USB..nothing, garmin goes into mass storage
- power off garmin than power it on while holding both buttons than connect USB...nothing, garmin goes into mass storage
- power off garmin than power it on while holding power button than connect USB...nothing, garmin goes into mass storage
The only thing that was changed is that one of the combo above rested all settings and also deleted all workouts..
ps: garmin drivers are installed, FW 510 pre-installed. I also googled how to enter pre-boot on Edge series but without much success..
before connecting the Edge USB press and hold (keep it pressed) Lap/Reset button
You have to navigate to get to the good.
Galaxy S5 Kitkat 4.4.2 / Nuvi1200->1250 / Nuvi3790T->34xx / Nuvi 2200 / Nuvi 66 / Oregon 600
@janch: an important detail is the timing, ie, the exact moment to connect the USB cable in the GPS, valid for almost all Garmin GPS.
Pressing and holding the Lap/Reset button, connect the computer's USB cable at the time when you see the Garmin logo.
At that moment the GPS should be recognized by Updater.exe, click OK and wait for installation.
Nuvi 3597; 3490; Etrex 30; Oregon 200 (from Approach S5)
For information: No need to use the Updater for your Edge 1000 to install the patched firmware, because its original fw 5.10 does not contain a GVS check.
You can use the patched GCD file directly for flashing.
Last edited by Cnfhbr; 5th December 2015 at 06:07 PM.
Thank you all for your suggestions! I'll try asap.
@Cnfhbr if I understand correctly, I can drop pached .gcd directly to webupdater.exe..or how can I patch directly? Sorry for rookie questions, but I'm not so good with Garmin devices...Shame on me!
Please don't spam. Posts serving no purpose other than to thank or to ask about hidden links are trashed or deleted, it's GPSPower's policy. Please don't spam.
[Only registered and activated users can see links. ] should make their first post as a new Intro Thread in [Only registered and activated users can see links. ].
Yes, It worked (drag & drop)! All maps are unlocked now