I don't know. I sent a route from Basecamp this morning, and it never starts anymore.
Printable View
I don't know. I sent a route from Basecamp this morning, and it never starts anymore.
Maybe it wasn't formatted correctly. Perhaps a setting was wrong on RMPrepUSB. Format it with RPPrepUSB using these settings:
[Only registered and activated users can see links. Click Here To Register...]
Create an empty Garmin folder. Then load orig fw again, check it can still be seen in MSM and run WebUpdater. Don't add any files from your backup yet.
After formatting, I created a empty Garmin Folder. Disconnected Zumo from the computer and flashed the Original Fw, but then it doesn't come into MSM anymore.
Do you think I'm doing something wrong flashing the original fw?
The only difference in the Formatting settings that i made in the first time to yours, is the Set Partition as non bootable
I was writing the same, but
1)cure worked, because he could enter storage mode
2)He said he formatted it with RMprepUSB, I suggested to add garmindevice.xml in a Garmin directory only.
3)original .rgn flashing makes zumo a brick again.
It looks it's original fw to brick it.
May be he made something wrong extracting original .rgn and flashing it ?
I flashed the original Fw in two different ways.
direct the rgn that i use to create a cure
using this rgn that i create a cure in cure3 creating a original, actually a original from a original ...
Use RGNTool, load gupdate.gcd and save it as RGN.
[Only registered and activated users can see links. Click Here To Register...]
Flash it by Updater.exe in preboot.
you mean the gupdate.gcd that i get from the device after run webupdater?
yes, or get it in Zumo software page (click source of the page in browser)
Code:http://www8.garmin.com/support/download_details.jsp?id=4469
http://download.garmin.com/software/zumo660_GCDFile__510.gcd
The same result.
After I flash the rgn file it came back bricked. Sorry